Linode Forum
https://forum.linode.com/

transfer between Linodes using ipv6
https://forum.linode.com/viewtopic.php?f=19&t=7748		 Page 1 of 1
Author:  randymized [ Thu Sep 15, 2011 4:34 pm ]
Post subject:  transfer between Linodes using ipv6
Since ipv6 addresses can apparently be used in place of a private ip4 address for communication between Linodes, I figured I'd try it out, but I'm not able to ping the other Linode, much less ssh into it.

ifconfig reports the following local address for eth0:
Quote:
inet6 fe80::f03c:91ff:fe96:fca9/64 scope link


But
Quote:
ping6 -I eth0 fe80::f03c:91ff:fe96:fca9
from the other Linode reports
Quote:
Destination unreachable: Address unreachable


What am I missing?
Author:  funkytastic [ Thu Sep 15, 2011 4:45 pm ]
Post subject: 
That's a link-local address, which doesn't allow routing. You'll want to use your public IPv6 address to communicate between your linodes.
Author:  randymized [ Thu Sep 15, 2011 5:15 pm ]
Post subject: 
Code:
ping6 -I eth0 2600:3c00::f03c:91ff:fe96:fca9
also results in a "destination unreachable" ping result.

By the way, what is a link-local address for if not for communicating between two devices on the same network?
Author:  hoopycat [ Thu Sep 15, 2011 9:28 pm ]
Post subject: 
Link-local addresses are mostly used to bootstrap stateless autoconfiguration. The first 64 bits (fe80::) will be predictable and the last 64 bits will be unique to that interface. It allows there to be a sensible source address for neighbor and router solicitations to the appropriate multicast groups.

But that's neither here nor there... obviously, something isn't set up correctly.

First, omit the -I eth0 from the ping6 command. You shouldn't need it. That's what the routing table is for :-)

Secondly, do you have any iptables or ip6tables filters blocking ICMP or ICMPv6 traffic? IPv6 makes significant use of ICMPv6, and it shouldn't be filtered.

If neither of those are it, what are the outputs of "ip -6 addr" and "ip -6 route" ?
Author:  mnordhoff [ Thu Sep 15, 2011 11:45 pm ]
Post subject: 
Plus, don't forget *both* machines have to be set up correctly to communicate with each other! Even after you fix the f03c:91ff:fe96:fca9 one, the other one might be broken too. You might want to try ping6ing something else too, e.g. ns1.linode.com or ipv6zombo.com, to make sure that the *source*'s IPv6 works too.
Page 1 of 1 All times are UTC-04:00
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/