Linode Forum
https://forum.linode.com/

Adding another IP
https://forum.linode.com/viewtopic.php?f=19&t=878		 Page 1 of 1
Author:  mikeshoup [ Mon May 17, 2004 8:06 pm ]
Post subject:  Adding another IP
I purchased my linode with 3 IP addresses. I just now bought a fourth. I tried adding this 4th the same way I did the other IPs.

Here is the settings:
Code:
eth0      Link encap:Ethernet  HWaddr FE:FD:42:A0:8D:58
          inet addr:66.160.141.88  Bcast:66.160.141.255  Mask:255.255.255.0
          inet6 addr: fe80::fcfd:42ff:fea0:8d58/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:679819 errors:0 dropped:0 overruns:0 frame:0
          TX packets:651559 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0
          RX bytes:115625141 (110.2 Mb)  TX bytes:82652703 (78.8 Mb)

eth0:1    Link encap:Ethernet  HWaddr FE:FD:42:A0:8D:58
          inet addr:66.160.141.89  Bcast:66.160.141.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

eth0:2    Link encap:Ethernet  HWaddr FE:FD:42:A0:8D:58
          inet addr:66.160.141.9  Bcast:66.160.141.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

eth0:3    Link encap:Ethernet  HWaddr FE:FD:42:A0:8D:58
          inet addr:66.220.1.177  Bcast:66.220.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)


eth0:3 is the one not working.

Anything look wrong? Or am I missing something? Do I need to change gateway info or something? thanks.
Author:  Bill Clinton [ Mon May 17, 2004 8:11 pm ]
Post subject: 
Though I cannot answer your question (sorry!) I do suggest that in future postings you remove your IP addresses from the post. Or use an X.X for the last two numbers in the IP address. A little privacy doesn't hurt, but it goes a long way. Or thats what I used to believe when I was the prez.

Bill Clinton
Author:  caker [ Mon May 17, 2004 8:16 pm ]
Post subject: 
You need to add the gateway for the different subnet that your fourth IP is in:

Code:
route add default gw 66.220.1.1


-Chris
Author:  mikeshoup [ Tue May 18, 2004 12:03 am ]
Post subject: 
I did that, and still no go
Author:  caker [ Tue May 18, 2004 1:16 am ]
Post subject: 
Looks like you didn't reboot after purchasing the IP. Reboot, bring the interfaces up (including the default route), and then it should work...

-Chris
Page 1 of 1 All times are UTC-04:00
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/